Replacing Door Hinges

Here is some great advice on a common installation:
Whether it's because your door is old and no longer works with your décor, or you want something a little more flashy in the space, trading out doors and door hinges is not too difficult of a job.
Don't think you can do it? Think you need a lot of tools to get the job done? Think again. All you need is a few shims, or thin pieces of wood that can be slipped under the door to hold it at the right height, nails or an electric screwdriver and the door and door hinges.
Here are the steps for taking on the installation process.
Selecting the what you need is easy. Measure the old door that you are taking out of this space and write those measurements down. When it comes to selecting door hinges, consider what this door will be asked to do. If the door is going to get a lot of use you may want to use three 3-inch door hinges to make sure it's sturdy and will hold in place. This is especially the case if it is an exterior door. One way to tell what kind of door hinges to choose is to look at what was being used on the door you are removing.
The easy way to install the door and door hinges is to install the new door hinges where the old ones were. This only works if you selected the same size door hinges as you previously had on the door with proper hole-spacing. If not, you may have to use some wood putty to fill the old holes, and then put the new hinges wherever you would like.
When deciding where the door hinges will go remember, doors are supposed to open into the room, they are also traditionally expected to open to a wall, not to flap in the open area of the room.
If you have someone handy, you may want to bring them into play at this time. Line up the door where you think it should be placed, using shims to balance it off the ground enough that it will open and close. You should put the first screw in at this point, at the top of the door. Make sure someone is holding up the weight of the door (or keep it on shims) so the weight doesn't pull that screw out.
Close the door and make sure it shuts properly. It should be hitting the strike plate evenly. If not, adjust the shim placement until you have even amounts of space all the way around and the door seems to be evenly set. Immediately put a screw in the bottom door hinges. This will make sure you have the door hinges lined up in a manner that will allow the door to open and close correctly.
With this screw in, check one more time to make sure it's lined up properly, then install the remaining screws in the door hinges and the job is done.
Jennifer Akre, the author of this article, is an owner of different niche sites that offer clients and customer not only products, but information relating to furnishing and decorating their indoor and outdoor living space. Whether you want to redecorate your living room or create the ultimate outdoor oasis, there is a ton of helpful advice to take advantage of. Today, she shares her insight when purchasing lavish cabinet hinges, luxurious door hinges, and useful hinges
Article Source: http://EzineArticles.com/?expert=Jennifer_Akre